For GM HEI coil in cap this connector helps clean up your engine bay by eliminating the use of single spade connectors that are prone to falling off and killing your ignition. This connector is a tight positive fit with a locking tab and shark fin on it to ensure that the connection between your wiring and HEI stays intact. The connector houses two wires, one bright red for your 12 volt key switched wire, and the other green for you tachometer to wire up. The high temperature connector has 2 ten inch leads coming out of it.
You can write any text to be displayed either here if you want it to show on all products or create a custom metafield for products where you can add text information specific for each product.
| Part | Size | Diameter | Width | Height | Weight |
|---|---|---|---|---|---|
| Car Tire | 17" | 215 mm | 17" | 25" | 8 kg |
| Alloy Wheel | 18" | 225 mm | 18" | 24" | 7.5 kg |
| Brake Disc | 12" | 280 mm | 12" | 15" | 3 kg |
| Exhaust Pipe | Standard | 200 mm | 150 mm | 40" | 5 kg |
Related Products
Order online and have your products delivered to your closest store for free
-12%
Sold Out
Brand: MSD
CAN-Bus Extension Harness for Power Grid System
CAN-Bus Extension Harness for Power Grid System
-12%
$89.15
$100.95
-11%
Sold Out
Brand: Holley Sniper EFI
Replacement harness for HyperSpark and HyperSpark 2 Ignition Boxes
This harness includes switched 12V, battery+, battery-, ignition coil wire, and output wires for points or electronic ignition amplifier. Harness is wrapped in protective split wire loom for increased protection...
-11%
$33.63
$37.83
-11%
Sold Out
Brand: Holley Sniper EFI
HyperSpark Plug and Play Main Harness
With our HyperSpark plug and play main harness, you replace the Sniper 1 main harness and use the new harness to connect your HyperSpark components. Designed to be used when...
-11%
$320.95
$361.95
-11%
Sold Out
Brand: Holley EFI
For Pro-Billet Distributor or Magnetic Crank Trigger to Sniper 2
Provide RPM signal to the ECU for your Sniper 2 while not using timing control. With two wires, it's quick and easy to install in your vehicle.
-11%
$39.24
$44.15
-11%
Sold Out
Brand: Holley EFI
Firmware Updating - Dash Configuration - ECU Testing
Also includes a power switch for quick setup in your workspace. Power and Ground flying leads need to be connected to your battery or power supply. (Not included)
-11%
$231.95
$260.95
-11%
Sold Out
Brand: Holley EFI
99-04 2 Valve Ford Modular Coil Harness, For HP EFI & Dominator EFI
99-04 2 Valve Ford Modular Coil Harness, For HP EFI & Dominator EFI
-11%
$231.95
$260.95
Recently Viewed Products
Sleeve High Neck Bodycon Dress
$132.00
Lorem ipsum dolor sit amet, consectetur adipiscing elit. Nam fringilla augue nec est tristique auctor. Donec non est at libero.